F16V3 + Falcon Expansion + F8 Distro x 2
With a full size top you can fit tons of equipment on this mounting kit
If you need tons of power and equipment in one single box, this is absolutely the design for you. Featuring up to 4 stackable power supplies and a full size top plate, this double decker design can fit it all.
Jdeation Featured Design
Design ID : L01KDH76
Designer : jchancel
Assembly instructions for - MTM ACR8-72 Double Decker w/ Full Top
View our detailed walkthrough video for instructions on how to use the JDeation Designer
Most parts are available at home depot - all are available online.
Print your design on your home paper printer to scale.
On your design, click the download button and select PDF (Print). You must open the PDF in Adobe Reader to get the advanced print functions. Do not open the PDF in your browser. From the Adobe Reader print dialog box, select the following options.
Image of design printed to scale:
Screw Size | Drill Size | Typical uses |
---|---|---|
4/40 | 1/8" | Component standoffs |
#6 | 5/32" | Self tapping screws for mounting to enclosure |
#8 | 3/16" | 3" and 4" Bolts for P.S. and Shelves |
#10 | 7/32" | 6" Bolts for P.S. and Shelves |
NOTE: Occasionally the fabrication process will remove one or both sides. If you can see through the acrylic clearly then the film is gone.
Depending on the design, power supplies are either attached via mounting brackets, or screwed directly to the bottom plate. If your design requires the power supplies to be screwed to the bottom plate, attach them now using M3 or M4 screws.
If your design requires the use of STACKED 350w Power Supplies, attach the mounting brackets to the bottom of your power supply using the 4mm screws and either horizontal or vertical mounting bracket
WARNING: DO NOT OVERTIGHTEN
WARNING: DO NOT OVERTIGHTEN
If your design is using stackable power supplies or clamp style power supplies, insert the power supplies using the example pictures below as guides. See diagram below for spacer / nut ordering. You control the distance between the power supplies through how long you make your spacer. The spacers are held in place with a K-Nut. No washers needed.
Power supplies can be offset mount to allow easier access from above to the power supply wire connection screws.
Works with both full size and slimline power supplies
Use clamp style mounts for power supplies that do not have mounting holes. Show is an HP Common Slot Power Supply. The mounting brackets essentially clamp the power supply in place.
You can also add a spacer on top of the top power supply to make threading the nut on the bolt easier
Few tips:
Use our contact page if you require assistance with your build.